How to shorten a lace wedding dress the easy way

HOW TO SHORTEN A LACE WEDDING DRESS THE EASY WAY..

2016-09-08-08-16-45

 

Here is the secret.  A simple way to shorten a lace wedding dress.

The dress above was drooping on the floor 1 1/2 inches.  The lace is delicate and very difficult to unpick.

Shortening a lace wedding dress can be a daunting task but there is a simple way to do it.  20160829_100924These instructions are for a lace dress with a train.  The lace is along the bottom and looks like it is a part of the fabric but if you look closely you will see that it has been sewn on.   Unpicking all those tiny stitches on delicate lace is not a good idea.  You run the probability of damaging the lace and leaving holes in it.

CUT ALONG THE TOP OF THE LACE

20160829_100934Here is a simple way to change that hem.  Just carefully cut above the lace on the front of the dress if has a train.  The train does not need to be shortened. Just the front so insert your scissors above the lace and trim it off.  so it just droops down.  Co not cut the lace entirely off of the skirt in a piece.  Just cut where you see those dotted lines.

RAISE THE LACE UP TO DESIRED LENGTH-STITCH

20160829_100945

You can see in this drawing that the part you cut is just going to droop down.  Now…Ta DA!  Just raise the center of the lace up to the desired length.   Then carefully pin it.  If regular straight pins will not stay in then use safety pins until you get it right.  On each side of the lace section there may be a tiny pleat in the lace to accommodate for raising it above but it will not be noticeable.  Now top stitch it on with a medium stitch.  A fine polyester thread works great.  You may use invisible thread but it usually isn’t necessary.

TRIM OFF THE EXCESS BELOW

20160829_101000

In this drawing you will see the peaks hanging down from the cutting line.  Just carefully trim them off so they do not hang beneath the lace edge.

HEM THE LINING AND THE UNDERSKIRTS

Now you will have 2 or three underskirts to hem.  they also only need to be shortened in the front You will want to trim the Satin underskirt to match what you did with the lace. for the underskirts I like to just turn them up and leave the extra fabric in there to make the bottom of the slips firmer and stand our  more.  That would depend on the wishes of the bride.